[Darrin Wright]

Had a delivery of parts during the week, this enabled me to:
fit the hub locking washer to the L side and bolt axles in
fit a new shaft for the clutch fork, into the gear box
fit another starter motor and play around with that
fit the gear box output yoke (drive coupling) to the gear box

I also assembled the exhaust system into the back of the hull with new tail pipe brackets. Then lifted the rear armour diff cover into position to test fit the tail pipe positions and where the mufflers will sit. From this I will now make the brackets to mount the mufflers and finish the exhaust system. Will also straighten the mounting brackets for the rear armour diff cover as this determines how/where the exhaust sits.

Sorry, not much to take pictures of...