View Single Post
  #19  
Old 28-05-13, 22:59
motto motto is offline
Registered User
 
Join Date: Apr 2010
Location: Woodend,Victoria,Australia
Posts: 1,068
Default

Darryl, if you PM your email address I will try to get you the wiper slot photo. I also have a camera problem that will delay things a little.

To describe things a bit better re the wiper slot:- Starting with the blank plate drill a 1/2"diameter hole with the centre 3/4" up from the lower edge. That creates the upper end of the slot. Next, counterbore that hole from the rear face 7/8" diameter X.230 deep. Lastly, remove just enough material to create a 1/2" wide slot from the original 1/2"hole to the lower edge. Job done! DO NOT EXTEND THE COUNTERBORE.

David
__________________
Hell no! I'm not that old!
Reply With Quote