[Warren Quin]

I'll ask Brian than as I have no means of making something.

Everything is good. No loose springs, it steers fine, I had no problems aligning it... It just that the tie rod doesn't work with the bend in it as is...

Edit: I just went out and jacked it up to verify the springs. It had to go up almost 2.5 inches for the angles to look like they would clear and the shackles were pretty much vertical. I don't think that's right...

I will just have to keep looking...

If you have a unit with this bell crank could I get a picture or two of the tie rod angles for comparison? One of the problems is I have nothing to compare it to...

Thank again
Warren