Hi,
I am trying to refit the front hub to the axle on my F15A and I have struck a problem. I have a mystery washer and I can't figure out where it goes. It is 93.7mm (3 11/16 inch) OD and 71.4mm (2 13/16 inch) ID. It is bevelled on one of the inner edges. It is much bigger than the shims that are on the outer axle. It is not listed in the parts book and it is not obvious in the front axlre cut away in the maintenance manual. It must go somewhere as I have one for each side.
Any ideas?
