Engine Rotisserie
Hi All
Got another restoration tool to add to the collection. I have never liked the common engine rotisserie because they generally just bolt up to one end of the engine which puts a lot of load on just 4 bolts going into the cast iron.
Particularly with the Chevy 6 that's a lot of length and a lot of weight. See picture of 261 engine on stand upside down.
Well when I started working with a Flat Head engine which while shorter, are heavier in this particular case, decided it was time to fully support both ends of the engine. The second photos shows what I came up with an adjustable front support, now the engine rotates very easily as it does not have the bending load on the single pipe swivel used in the standard commercial unit.
One afternoons work and now I wonder why didn't do it earlier. The only real time consuming part was making front adjustable in height because the commercial units actually have a 6-7 degree up angle in the swivel to compensate for the bending force when the engine is bolted on. So to take a 6 cylinder or a V8 you need to be able to raise/lower the front swivel so that it is line with the rear at the correct length.
Cheers Phil
|