Quote:
Originally Posted by Phil Waterman
Hi Ryan
The other thing to consider in this topic is how do you rig to pick up some of the major components.
|
Here's something to start the ball rolling. This is a lifting frame I made a few years back to lift Ford sidevalve V8's with or without the transmission attached. It only requires the intake manifold to be removed. (See attached photos)
I borrowed the idea from the Ford CMP Maintenance Manual where they use a steel block placed inside the valve gallery to lift the engine and transmission as a unit.
Basically it is a piece of 75 mm x 50 mm RHS steel with two 75mm x 75mm x 5 mm steel angles welded to it. I drilled 8 holes in the angles to spread the load over a large area of the top of the block using the intake mainifold for their spacing, two holes front and back, four in the middle. Drilled a series of holes 55 mm apart and used a spare towing shackle to the crane via a smaller shackle. Depending on lifting a bare block, a full block, or one with the trans attached I select one of the four holes. By dumb luck the last hole at the rear was the perfect balance point for engine and trans attached. It is 115 mm from the end of the frame.
Works well in confined areas.
Cheers,