search for the break in the wire..its probably pinched or it broke at a joint through the fire wall? shorted at the gromet? maybe the pin is off the end at the connector> keep testing with a shapt line teaser from one end till you do not get power...then you know where the break is...use an ohm meter or a bulb and a battery and just use one end of the circuit using the wire and follow the wire using a sharp in etc to go through the wires inulation to get the bulb to light when you have gone past a point where the bulb no longer lights...the break is there between where you last tested and the place before.
Hope that helps! Oh is the switch for the lights to the head light position? not just driving or black out light? position..the three handled switch? some times if you click that switch off and on a few times the comtacts clean off a little for a cureent to pass through. check the switch on the dash.
Good luck and let us know.
__________________
M38A1 CDN 53-32490
|