Looks good Phil
....one word of caution....
When building the ramp..... the front separate rectangualr section is a bit short in the flat area...mine was 18 inches plus 2x 2 inch tube cross section for a total of 22 inches........ I would strongly recommend at least 4 preferrably 6 inches longer if you intend to use a 20 inch tire..... because when you remove the back ramp section it is a bit short......
Meanwhile will look forward to the plan or sketch of your engine stand and some explanation of the rear (adjustable ? ) engine support to the bell housing.
I am gradually collectig supplies for my rotisserie.....
Bob
__________________
Bob Carriere....B.T.B
C15a Cab 11
Hammond, Ontario
Canada
|