Quote:
Originally Posted by Private_collector
Attachment 44132 Attachment 44133
This weekend I got the drivers side hub off & removed all bearings from both sides. As with the mates side, the drivers side hub nuts showed signs of chisel marks in direction of loosening. Nuts are OK & needed only a filing down to remove burrs. Notice the 'dimples' on the stub in the 2nd photo? Only short axle end had these. Other end would have been done by someone else & I guess they had other ideas.
|
Tony,
Looks like the stub has been worked over with a centre punch, creating raised dimples. This is sometimes done to give the inner bearing race a bit of grip to prevent it from rotating.
HTH,
Hanno