Quote:
Originally Posted by andrew honychurch
. I have to make some new oil cooler pipes for both the engine and diff coolers. These are 1/2 in steel and have double flared ends. The curves are intricate and sharp. I cannot see that I can bend 1/2 in copper nickel and even if I do I have not got a man enough flaring tool for 1/2 in. I priced up the latest Sykes Pickavant tool but its over £250 just to make up some pipes as a one off. Ummmh. Anyone know whether trucks use steel air piping at this size? My thought being that if they do, some friendly fitter may be able to make my pipes for me? Anyway, hope you enjoy the photos.
|
Hi Andrew,
You could try Pirtek, near Ashford Market, they are hydraulic pipe specialists, not just hoses.
I have a Sykes flare set, but not sure if it goes to 1/2", will check tomorrow.
regards, Richard