Willing an able....
Hi Stuart
Already have the 2 jacks..... earlier model with hand pumps.
For the hub best bet is a single trailer hub from PA for one end.... the other end.... the end that makes it turn is best set up with a worm drive reduction gear box that can be driven by hand or with an impact wrench... they are about $175 new at PA or cheaper if you can find them at a flea market ... the larger the better and the slower the gear ratio the better....
We need to have a session in the barn to finalize the design... with some scrap steel and a flip chart to sketch our ideas.... the rest is just cut and welding.
I favor two independent end units... the driven one as a stand alone so it can be used for smaller parts.... and adjustable square tubing to adjust for length.
when is a good time...?
Bob
__________________
Bob Carriere....B.T.B
C15a Cab 11
Hammond, Ontario
Canada
Last edited by Bob Carriere; 11-02-11 at 22:08.
|