Fantastic. thats really helpful and I am most grateful. I have been thinking about this today, and that exactly the design I came up with . ( I would say that wouldnt i?)
I managed to pick up a track jack today and it is not safe for the job. Basically the fingers dont grip well enough and the jaws can swivel so it constantly twists. You are quite correct that the spring tension is enormous and I think you could brain yourself or take a finger off in a sprice.
I need to go get some pip, I recokon on 1 5/8 O/D which will sit in the recess where the nut normally sits and sit nice and square. Then I can wind the spring up to my hearts content. Thats the job for the weekend.
What i also reckoned was that it one thing getting these springs off but getting them back on will be pretty tricky so having a nice square pull with this puller will make the job safer and easier.
I really appreciate your help
thx Andrew
|