thanks dirk and yes the table is strong enough for a couple dozen pints of beer so very handy this table
I started on the air vents that sit on the roof there are 4 of them, 3 the same size and one big one for the generator. I have 2 small ones (one bad) and the big vent with some dents in it.
so I had to make some new ones. the first thing was to make a new bottom
for all 3 small vents. then 2 new vent body's because one was to bad to fix.
I used the old one as a example for the others. when I cut the sheet metal I had to watch to cut it right then I could bent it into shape.
It needs only a little bit of welding. there is also a rond piece of tubbing that fits in the roof. the bottom plate goes on the roof and then the body goes over it and is screwed together to the roof. I will do this later when I have more time. (see more pictures in the next thread reply)
cheers jaap