Relocation of Timing mark
Hi Bob
I've done just what you are talking about of moving the timing mark to somewhere you can actually see it. The little inspection hatch on the top of the bell housing. I just line the timing mark up carefully through the normal timing window behind the starter. Then with a lettering punch I make a corresponding "O" on the back of the clutch housing in line with a fine wire strung between the two bolts. See the picture.
Not really shown in this picture but something I've started doing as I resemble engine and clutch units is I paint two inches to on the advanced side of the timing marks both new on clutch and on the normal flywheel position. This really helps when the timing is way off to find the timing mark.
I have copies of this photo with my manual on the computer in the shop to remind me on which side of the bolt to wind the wire.
Cheers Phil
|