View Single Post
  #7  
Old 06-12-10, 02:31
David DeWeese David DeWeese is offline
Registered User
 
Join Date: Sep 2005
Location: Plano, Texas
Posts: 357
Default

Thanks for the kind words, Jaap.
Did some woodworking this weekend on the rear body. This type body uses tongue-and-groove lumber for the front panel, floor and tailgate, and maybe some in the lower lockers also.
Haven't worked with wood much, but was able to make the lumber after a few failed attempts. Still have to bolt it all to the front panel....
Had a setback in that the Chevrolet Blazer rear axle I installed will be too wide once the rear fenders are put in their correct place. The problem didn't become noticeable until the rear body was on...
Think I have found a suitable, cost effective replacement for it, though.
Thanks, David
Attached Thumbnails
DSCF0210.jpg   DSCF0218.jpg   DSCF0216.jpg  
Reply With Quote