View Single Post
  #218  
Old 29-08-10, 00:46
David DeWeese David DeWeese is offline
Registered User
 
Join Date: Sep 2005
Location: Plano, Texas
Posts: 357
Default long day.....

Hi,
I've been dreading the repair of the right fender as it was badly damaged on the front. The fender had been hit so hard that even the heavy bracket that holds it, and the headlight, was badly twisted.
After beating the fender back into rough shape, a test fit confirmed even more damage to the main angle iron frame that the entire cab is built off of.
I opted to cheat a little,(a lot), and weld washers to the edge of the fender that would line up with the mounting holes on the bent framework.
Pulled all of the front cab sheetmetal out to test fit them and see if any more alignment issues came up before painting them. Luckily, the front piece with the air ducts cover the washers that were welded on, and all looks good to proceed....
Have a question about the holes in the hood. What goes in these holes? Don't remember taking anything off the hood, but you can still faintly see an outline where something had been...
Thanks, David
Attached Thumbnails
DSCF0068.jpg   DSCF0072.jpg   DSCF0076.JPG   DSCF0077.JPG   DSCF0074.JPG  

Reply With Quote