division plate measurement
Hi all, Lew Skelton here, I have lurked for a while but its time to pick the collective brains. Im in the process of making one LP2 carrier hull from approx two and a half cut to bits or rusted hulls. Iv'e started rebuilding the front half, currently working on the bottom of the division plate ( crumbly rust ) and wondering if anyone has the diameter of the holes that the brake rods pass thru and are they round or slightly oblong? and the distance the hole is from side and floor plate
thanks in advance
And yes Lynn I finally pushed the hull into the garage and can now park in driveway.
Lew
|