[Lynn Eades]

Put the rod assy in a press, on a plate with a hole it, and push against the spring. be careful. I,ve fought and struggled with mine, but it was a while ago, and at that time I had access to some good gear, like the 100 ton press.
The plates between the springs sit against a collar on the rod, so each comes off their own end. If your rods are rusted to the balls, then they cant have been too badly worn
David started with not much. He told me that he had all his springs made.

It would be good if you can run a few photos of the process. no doubt it will help a few people who havent done theirs yet.