been busy lately seling my daily driver and shoping for a new older one, then i sold the 54 and the 53 , so it was quite the running around, and the weather was kind of crappy , but i still managed to get some stuff done, i took the box off the 52 and salvaged wath i wanted under and in it , and then i started stripping axles to get to some decent gears, the first set i took out of the 55 was a bit slim at one point but not as bad as the set i took out of the rear of the 52, the pinion is almost paper thin , i looked in the setting intruction in my shop manual and all they talked about was bering preload and no mention of any pinion depth or gear mesh partern, i then understood why my gear where in such poor state lol, then i took the shaft out of the front axle the joint are an interesting concept compare to a u-joint kind of a constant velocity birfield, then i got the gear out and finally i had a decent set even if the pinon was set a little far from the crown and there was 30 thousand of back lash in the set, so i took all the best part appart and cleaned them, the carrier is a pain to take appart but i am happy i did because i had a trust washer that was fubared,
also my girlfriend sanded down some spot where some sticker had been painted , if you can identifie the unit or sticker let me know
anyhow here are all the pics! enjoy!
unknown sticker, on the door
![](http://i298.photobucket.com/albums/mm273/pauljboudreau1/hiver09-10187.jpg)
we also found all sort of paper work in the dash from dnd and the rangers