Area around master cylinder
Hi John
Looks like you are making very good progress, as you will probably remember the area around the master cylinder gets crowed with brake lines, fuel line, wiring harness, battery cable and the speedo cable. It also gets very hard to work in once the engine is place.
So now is a good time to get the routing for each of these figured out and locations for all the cable/tube clamps located and sorted out. Consider putting all of the cables and lines in place even if you just put the clamps in place loosely.
I mention this as I had major problems with my Pattern 12 when the speedo shorted out on the brake light switch lugs. Burned out the speedo cable, battery cable, wiring harness, and almost through the RUBBER fuel line, about the fuel line be sure to run steel through this area. Cause for all the problems was that I didn’t have all the locating clamps in place on the speedo cable.
Cheers Phil
|