Day 19
Being a Sunday work was limited. Today we accomplished the following:
Removed the floor and the interior engine compartment walls.
Removed the master cylinder and all brake lines.
Removed the drive shaft.
Removed the starter solenoid and cable.
Took pictures before and after work that was done.
Am missing the driver's side floor support. Any ideas where I can find one? (See the picture.)
Noticed that the wood spacers that separate the floor from the frame end at the rear of the cab floor. However, because they are groved on the end I suspect they run back farther underneath the bed and possibly with another two short pieces placed on the frame ends right at the back end. Can somebody help educate me on that? (See the picture.)
Started at 7 am and quit at 11 am. Too hot!
Regards,
Jim
|