MLU FORUM - QL Bedford

MLU FORUM (http://www.mapleleafup.net/forums/index.php)

- The Softskin Forum (http://www.mapleleafup.net/forums/forumdisplay.php?f=5)

- - QL Bedford (http://www.mapleleafup.net/forums/showthread.php?t=9624)

:sheep: Hi Can any one tell me or have a photos of rear tail lights for cargo body;also need good steering wheel,what the fittings are on rear cab wall, cheers Reg.

Quote:

Originally posted by baldeagle
:sheep: Hi Can any one tell me or have a photos of rear tail lights for cargo body;also need good steering wheel,what the fittings are on rear cab wall, cheers Reg.

Hi Reg,

I have a QL, in fact have now owned it for 20 years. During wartime service, only one tail light was fitted, on the drivers side, subsequently, postwar, to comply with traffic regulations they then had two rear / stop lights, these were never all the same, probably down to the workshop fitting them and what was available. I do not have a spare steering wheel. As the fittings you are asking about, could be postwar additions, can you post a photo up to see what you have? I assume you mean inside the cab.

Thanks Richard ,I have two small tube marker lights ,just found not sure if right; also one larger think it for diff marker light,the smaller ones fit in to L R tray slots.Yes inside cab ,will post photos next few days, Thanks RG.

Quote:

Originally posted by baldeagle
Thanks Richard ,I have two small tube marker lights ,just found not sure if right; also one larger think it for diff marker light,the smaller ones fit in to L R tray slots.Yes inside cab ,will post photos next few days, Thanks RG.

Reg,

The two small markers, with a red lens, would be about one inch / 25mm diameter. The larger tubular lamp fits up on the chassis pointing towards the rear face of diff housing.