u.c. parts
 

have dragged an old carrier out of bush in order to use some parts for our restoration of a mk.1 have some parts that are not needed and willing to sell to offset cost of other parts. have some pics of same. thanks mike harrison cobalt on.

Mike, check your PM

I am after the front to rear brake linkage rods complete and the steering yoke pin. ( I could not figure out the correct thread to make my own )

Please see your pm's, thanks.

Looks familiar
 

I think that was one I looked at a few years back.

Was on the wrong side of a lake from the nearest roads?

Here is a pic....

.....
 

Too late - I already PM's about that...

When ? That post has been up for ages..

Richard, buy the steel and have them made where you are. The freight would probably be $$$ because of the length.

Just wanted pucker ones.... Your right I should just make some here.

Richard-
 

I asked about them - didn't gat an answer though...

Ditto.... Nothing back to me either

No response.
 

I PM'ed an hour after post and nothing.

No response.
 

I am looking for wheels with good rubber. His look good enough. No answer to me.

Anyone else got some wheels with good rubber for sale?