Wireless set 19 Carrier 23
 

I must advance in the assembly of my WS19. It seems to me a good option to mount it on the Carrier 23. Any drawing with measurements to be able to build it? Thanks in advance!

I attach a drawing with the measurements I need.
Letteres A to H.
Also the thickness of the table.
Many thanks for your help!

A= 36 5/8"
B= 13"
C= 1 3/4"
D= 1/2" on rear cut
E= 25"
F= 3"
G= 3"
H= 3"

note - D measurement at front is different than rear. The notch is 1" in.

Bruce, thank you very much for your help.
The thickness 3/4 inch?
What type of wooden?

the large board is 1" plywood. The 2 smaller boards are 1/2" and may be fir or pine as it was made in Canada.

Ok Bruce! :thup:
The paint seems to be red varnish?

on my board the only varnish is where the decal is. The rest of the carrier doesn't appear to be coated.