Carrier Idler Wheel Re-rubbering
Hi all - I am considering commissioning a mold for this wheel, similar to my Carrier wheel re-rubbering. Before I do this I am looking for expressions of interest. I have no idea at this stage what the re-rubbering cost would be and I do not have any to do a sample run. Given that this would be a limited market, two per Carrier and the fact I do not have any, I need to carefully research the feasibility of this project. If anyone out there has a spare I could obtain it would be appreciated.
Bob |
Bob, can you not just use your first mold and turn the rubber down to the correct diameter ? or am i missing something (which is highly likely)
|
Missing Something
Hi Richard - these wheels are the upper track support wheels and only a quarter size of the track wheels.
Bob |
ahh the return roller... sorry i thought you meant the front idler wheel matey... my bad.
|
Those are small enough that they likely would be inexpensive to ship...are the Aussie return idlers the same as the Canuck ones?
|
No Go
Well due to the under-whelming response, this project will go on the back-burner.
Bob |
All times are GMT +2. The time now is 06:44. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016