Jeep engine overhaul questions
1 Attachment(s)
Not sure if I've posted this in the right spot, but needing advice. After removing a friends 1952 Jeep engine for rebuilding today, I need to know the proper or safest way to remove the front crank pulley. Removed the nut, there appears to be 3 tabs that stick out. It's a stamped metal pulley, not cast iron. Does it require a puller? Phil
|
G503
Phil
Maybe the guys on www.g503.com ..would be the best place to ask.. there is a sub-forum for the CJ2/M38 series on there ..if they dont know , nobody will Mike |
Thanks Mike. I found my answer with your link. Just tapped it lightly on the back side and after a while off she come. Phil :)
|
Jeep engine
Go To Williys military Jeeps.com There is a section for the M38 CDN jeep
|
All times are GMT +2. The time now is 00:40. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016